Jenn-Air JBL800 Mode D'emploi page 10

Turning the Blender Off
While the blender is operating, touch the "OFF" pad on the control panel or touch
the active speed setting pad a second time and the blender will stop.The "ON" pad
will still be illuminated and the WARNING light will flash to indicate the blender is
ready to operate again. Press the "OFF" pad a second time to completely turn the
blender off.
Auto Shut-off
• The blender will automatically shut off if allowed to stand with no control pads
pressed for 10 minutes.
• If two speed settings pads are accidentally touched at the same time, the
blender will shut off. Select desired speed setting pad to start or restart.
Pulse Mode
1.Touch the "ON" pad on the control panel.The "ON" pad will illuminate and the
WARNING light will flash to indicate that the blender is ready to operate.
2.Touch the "PULSE" pad.
3. Select a speed setting and touch the corresponding pad on the control panel.
4.The blender will operate only while you are touching the speed setting pad.
NOTE: When unsure about the appropriate speed setting, try pulsing to test
various speeds.
9