Operating Elements And Connections - IMG STAGELINE CPL-3DMX Mode D'emploi

DMX Interface and Controller
for 12 V or 24 V LEDs
These instructions are intended for users with basic
knowledge in DMX control . Please read these in-
structions carefully prior to operating the unit and
keep them for later reference .
All operating elements and connections de-
scribed can be found on page 2 .
1 Operating Elements
and Connections
1.1 Interface CPL-3DMX
1 LED for the operating mode
– lighting continuously:
no DMX control or music control
– extinguished to the beat of the music:
music control via the microphone (4)
– flashing steadily:
control by a DMX light controller or another
CPL-3DMX unit
2 DIP switches Nos . 1 to 9 to adjust the DMX
start address; DIP switch No . 10 without func-
tion
3 Button for automatic DMX address adjustment
☞
( chapter 6 .2 .1)
4 Microphone for music control
5 DMX signal input (3-pole XLR) to connect
a light controller;
Pin 1 = ground, 2 = DMX−, 3 = DMX+
6 DMX signal output (3-pole XLR) to con-
nect the DMX input of another CPL-3DMX
unit or DMX light effect unit;
Pin 1 = ground, 2 = DMX−, 3 = DMX+
7 Screw terminals for the LEDs (
8 Screw terminals for the operating voltage
The operating voltage must correspond to
the voltage required for the LEDs connected
(12 V min ., 24 V max .)
9 Connection jack for the remote control LC-3
8
1.2 Remote control LC-3
The remote control is available as an accessory and
not supplied with the CPL-3DMX .
10 Button STAND BY to activate / deactivate the
11 Button FUNCTION to select various functions
12 Button MODE to select the operating mode
Note: For control via the remote control, there must be
no DMX signal at the DMX INPUT (5) .
2 Important Notes
This unit corresponds to all relevant directives of
the EU and is therefore marked with
•
•
•
☞ chapter 4)
LEDs connected
depending on the operating mode selected
with the button MODE (12) [
– Stroboscope mode
The LED of the button MODE will not light
up .
– Selection of 9 preset colours
The LED of the button MODE will light per-
manently .
– Selection of 5 colour change programmes
The LED of the button MODE will flash slowly .
– Colour transition mode
The LED or the button MODE will flash
rapidly .
The unit is suitable for indoor use only . Protect
it against dripping water and splash water, high
air humidity, and heat (admissible ambient tem-
perature range 0 – 40 °C) .
For cleaning only use a dry, soft cloth; never use
chemicals or water .
No guarantee claims for the unit and no liability
for any resulting personal damage or material
damage will be accepted if the unit is used for
other purposes than originally intended, if it is
not correctly connected or operated, if it is over-
loaded or not repaired in an expert way .
If the unit is to be put out of operation
definitively, take it to a local recycling plant
for a disposal which is not harmful to the
environment .
☞ chapter 5 .2]
.