Rear - Sony IPELA NSR Serie Manuel D'installation

Rear

NSR-1200/1100
1
NSR-1050H
1
A Fan
Take care not to obstruct the fan grille. If the grille is
obstructed, heat may build up in the unit, leading to
damage and/or fire.
B Power switch
Press the switch in the 1 position to turn on the unit.
C RS-232C Connector
Use this connector to control analog cameras.
This connector cannot be used at the same time as the
RS-422/485 connector (four rightmost pins on F alarm
output connector).
D UPS connector (RS-232C)
Use this connector to connect the control line of the
uninterruptible power supply (UPS).
2 3 4
qf qd qs
2 3 4
qf qd qs
5 6
qa 0 9
5 6
qa 0 9
E Sensor input connector
Use this connector to connect the sensor input lines.
For connection details and wiring diagrams for sensor
inputs, see "I/O Port" (page 32).
F Alarm output connector
Use this connector to connect the alarm output lines.
For connection details and a wiring diagram for alarm
output, see "I/O Port" (page 32).
G HDMI monitor connectors (1 and 2)
Use these connectors to connect monitors that support
HDMI input.
HDMI monitor connector 1 and L monitor connector 1
(and monitor connector 1 on the front of the unit) cannot
be used at the same time, while HDMI monitor
connector 2 and L monitor connector 2 cannot be used
at the same time.
7
8
7 qg
8
9
Features and Functions