Sony IPELA NSR Serie Manuel D'installation page 23

Select the RAID type for the internal hard disk drive,
and click [Next].
Note
This screen only appears for models that support RAID
level modification.
Caution
If you change the RAID level, the RAID will be
restructured after the wizard is completed. RAID
restructuring may take a few hours depending on the
selected level and capacity.
↓
Configure partitions for the internal hard disk drive, and
click [Next].
Specify the number of partitions, and select the
percentage of total the capacity to assign each partition.
↓
Set the server name, and click [Next].
↓
Configure analog camera connection settings, and click
[Next].
Select the serial connector standard to which the camera
you want to control will be connected, and configure
settings such as baud rate and parity bits.
(This screen only appears when an NSR-1050H or
NSBK-A16/A16H (optional) is connected.)
↓
Select the video format for the analog cameras to be
connected, and click [Next].
(This screen only appears when an NSR-1050H or
NSBK-A16/A16H (optional) is connected.)
↓
Verify configurations, and click [Next].
↓
Click [Finish] when the restart confirmation message
appears.
↓
23
Step 3: Settings