Xyron GLAMINATOR Guide De L'utilisateur page 8

machine immediately and lay it on a fl at surface to ensure optimal quality. Keep your
project laying fl at inside the carrier until it is cool to the touch. This ensures optimal
foil transfer quality. When you are fi nished using your machine, return the slider
back to the "" position. In the event of a jam or misfeed, please see the release
REVEAL YOUR PROJECT
Once the transfer carrier is cool to the touch, carefully remove your project from the
carrier and lay it on a fl at surface. Slowly peel the foil off of your project. Discard
excess foil.
8
USE YOUR GLAMINATOR
Plug your machine in, and turn the slider
to the foil application ( ) setting. A green
light and beeping sound will indicate when light and beeping sound will indicate when
your machine is ready to use. Carefully
feed the transfer carrier into the front of
the machine as straight as possible, with
the sealed edge of the carrier pouch
fi rst. Once the carrier is in the machine,
the rollers will grip and guide it through.
Upon exiting, remove the carrier from the
button instructions on page 4.