Publicité
Les langues disponibles
Les langues disponibles
SET UP YOUR KITEBAR
Unroll your lines upwind from your kite (walking
up towards the wind). Untangle your lines as you
walk towards your kite keeping the front lines in the
middle and the back lines on each side. WARNING:
MAKE SURE THAT THE LEFT BACKLINE, WITH RED
CONNECTOR, IS SET ON THE LEFT. Then, check the
bridle to make sure that it's clear and untangled.
Make a lark's head knot with the front & back lines'
connectors (> 1 & 2). Connect the front lines (> A) to the
bridles' connectors. You can tie any of the front lines on
the left and right side of the kite's bridles.
1
2
-40°
+15°
B
RED
B
A
C
Then, connect your left back line (> B) recognizable
thanks to its red connector to the red ball of the kite's
tip (> 3 & 4). Finally, connect the remaining right back
line (> C) to the opposite ball (> 3 & 4).
WARNING: MAKE SURE THAT YOUR BACK & FRONT
LINES DO NOT CROSS EACH OTHERS.
3
-40°
+15°
C
A > FRONT LINES
B > LEFT BACK LINE
A
(RED CONNECTOR)
C > RIGHT BACK LINE
WIND
28
FRONT LINES TUNING - HIGH V / LOW V
The 4 Lines LiNX BAR offers two tuning possibilities for the front lines.
The tuning of the front line setting is made possible thanks to an aluminium V SPLITTER
located into the front lines.
To get the HIGH V setting, make sure that
the front lines are both running through the
V SPLITTER.
4
-40°
+15°
BREEZE V.1
V SPLITTER
To get the LOW V setting, take the
free-running line out of the V SPLITTER.
If you wish, the V SPLITTER can be taken
off completely from the front lines.
BANDIT
HIGH
BREEZE V.2
V
BANDIT S
BREEZE V.3
BULLIT
FURTIVE
TRUST
-40°
+15°
29
LOW
V
ONE
Publicité
