Features; Operation; Before Starting; Starting The Engine - Estwing E10GCOMP Manuel

FEATURES

1.
HONDA GX 160 4-STROKE ENGINE
For increased performance and superior reliability.
2.
10 GALLON TWIN STACK TANKS
Provides air supply for multiple pneumatic tools.
3.
CAST IRON PUMP WITH BIG BORE
CYLINDER AND PISTON
For durability and improved performance.
4.
10" NON-FLAT TIRE
Provides job site portability.
5.
OIL LUBRICATED PUMP
For cooler running temperatures and reduced wear.

BEFORE STARTING

1.
Check the entire unit for any damage, and make
sure all nuts and bolts are snug.
2.
Check to see that the quantity and quality of the
engine oil is correct.
3.
Make sure gas tank is filled.
4.
Clean or replace the intake filters if they are dirty.
WARNING:
Always check the oil/gas levels and
quality before start-up. Do not add or
change oil/gas while the unit is running.
Only use recommended non-detergent
oils. Refer to the Honda GX 160 manual
for recommended fuels.

STARTING THE ENGINE

1.
Move fuel lever to the "ON" position. If the engine is
cold, move the choke lever to the "CLOSED"
position. If the engine is warm, leave the choke lever
in "OPEN" position.
2.
Turn engine switch to the "ON" position.
3.
Pull starter grip lightly until you feel resistance, then
pull briskly and return starter grip gently - engine
should start. If not, repeat.
Features
6.
AUTOMATIC IDLE CONTROL
Reduces gas consumption.
7.
AUTOMOTIVE INDUSTRIAL AIR FILTERS
Increases air intake for greater efficiency.
8.
INTEGRATED CONTROL PANEL
For durability and improved performance.
9.
INDUSTRIAL GRADE RECOIL STARTER
Ergonomic design for faster and easier starting.
10.
ANTI-VIBRATION RUBBERIZED FEET
For less vibration and reduced crawling during use.

Operation

4.
Once engine starts running, slowly move the choke
lever to the "OPEN" position.
5.
With the engine running properly, the compressor
fills the air receiver with compressed air. When the
maximum pressure (set by the pilot valve control) is
reached, the engine and compressor will slow down
to idle speed, and will return to full RPM when the
cut-in pressure is reached. The unit will continue to
cycle automatically until turned off.
WARNING:
Engine idle speed may need to be adjust-
ed - even on your brand new unit - to
compensate for differences in altitude.
Please consult the engine operating
manual.
WARNING:
Extra care should be taken to avoid
personal injuries with automatically
controlled compressors.

STOPPING THE ENGINE

1.
Turn the engine switch to the "OFF" position.
2.
Turn the fuel lever to the "OFF" position.
05
Please contact 1-888-669-5672 for further assistance.
WWW.PRIMEGLOBALPRODUCTS.COM