Induction Cooktop Operation - hestan KIC Serie Manuel D'utilisation Et D'entretien

INDUCTION COOKTOP OPERATION

BEFORE USING THE COOKTOP FOR THE FIRST TIME BEFORE USING THE COOKTOP FOR THE FIRST TIME
All products are wiped clean with solvents at the factory to remove any visible signs of dirt, oil,
and grease which may have remained from the manufacturing process.
If present, remove all packing and literature from the cooktop surface.
Clean your glass top before the first time you use it. A thorough cleaning with a glass top
cleaner is recommended. It only takes a minute and puts a clean, shiny coating on the glass top
before its initial use.
• There may be a slight odor during the first several uses - this is normal and will disappear.
• Optimum cooking results depend on the proper cookware being selected and used.
• The cooking surface can get hot from the cookware and remain hot for some time after
cooking zones have been turned off.
• The glass ceramic cooking surface is a durable material resistant to impact but not
unbreakable if a pan or other object is dropped on it.
• Do not allow pans to boil dry. This can damage the pan, element and /or cooktop.
• Do not slide cookware across cooking surface, it may scratch the glass
• Using cast iron cookware on the glass cooktop is not recommended. Cast iron retains heat
and may result in cooktop damage.
Four burner cooktop with right and left
side (2) induction generators
POWER SHARING POWER SHARING
Four burner cooktops are divided into two separate heating zones.
Five burner cooktops are divided into 3 zones. One generator controls 2 elements, or two
cooking zones within a heating section share the power of one generator. Power Sharing is
activated when both elements in the same cooking zone are activated and one element is set
for Boost (P). The element that is not set for Boost will change to a lower power level. This is
called Power Sharing.
COOKWARE "NOISE" COOKWARE "NOISE"
When using adjacent elements that are set at certain power level setting, magnetic fields may
interact and produce a low whistle or intermitted "hum". Pans that completely cover the
element ring will produce less noise. A low "humming" noise is normal particularly on high
settings. These noises can be reduced or eliminated by lowering or raising the power level
settings of one or both of elements.
Five burner cooktop with right, center, and
left (3) induction generators
©2020 Hestan Commercial Corporation
EN
9