Electrolux 600cfm Instructions D'utilisation page 10

10
Converting the Blower
Replace Control Box Cover and
Attach Blower to the Chassis
Replace the cover on the Control Box and fasten with
the Phillips screw previously removed.
Attach the Blower and Slide Plate assembly to the
Chassis Housing by first sliding the Slide Plate
underneath the tabs and then fastening two ¼" hex
head screws in the outermost holes in the bottom slot
of the Slide Plate.
Refer to the Telescopic Downdraft System Installation
Instructions for further instructions on verifying the
proper operation.
Tab
Tab
Use Outer
Screw Holes
1/4" Hex Head Screws