Autosen AL001 Notice D'utilisation page 39

8.2 Explanation of the menu
For the factory settings please refer to the end of these instructions
(→ 13 Factory setting).
Configuration for output 1
4 switching functions can be selected:
[Hno], [Hnc], [Fno], [Fnc] → 10.2.3 Configuration of OUT1
Switch point for hysteresis function OUT1
Limit value at which the output with selected hysteresis function changes
its switching state (object nearer/farther than distance set)�
[SP1] is only active if [OU1] = [Hno] or [Hnc]�
→ 10.2.5 Setting of the switch point for hysteresis function OUT1
Switch points for window function OUT1
Limit values at which the output with selected window function changes its
switching state (object present / not present between the distance "near"
and the distance "far")�
[nSP1] = switch point "near" / [FSP1] = switch point "far"�
[nSP1] / [FSP1] are only active if [OU1] = [Fno] or [Fnc]�
→ 10.2.7 Setting of the switch points for window function OUT1
Configuration for output 2
4 switching functions and 2 analogue signals can be selected:
[Hno], [Hnc], [Fno], [Fnc], [I], [U] → 10.2.8 Configuration of OUT2
Switch point for hysteresis function OUT2
Limit value at which the output with selected hysteresis function changes
its switching state (object nearer/farther than distance set)�
[SP2] is only active if [OU2] = [Hno] or [Hnc]�
→ 10.2.9 Setting of the switch point for hysteresis function OUT2
Switch points for window function OUT2
Limit values at which the output with selected window function changes its
switching state (object present / not present between the distance "near"
and the distance "far")�
[nSP2] = switch point "near" / [FSP2] = switch point "far"�
[nSP2] / [FSP2] are only active if [OU2] = [Fno] or [Fnc]�
→ 10.2.10 Setting of the switch points for window function OUT2
Analogue start point
Measured value at which 4 mA / 0 V are provided�
[ASP] is only active if [OU2] = [I] or [U]�
→ 10.2.11 Scaling of the measuring range (analogue output)
UK