Ironside Prolaser 3D All-Lines Mode D'emploi page 12

Working in Pulse mode with a detector:
For outdoor work under direct sunlight or bright conditions, and for
extended indoor ranges up to 70 meters, use the pulse mode with
a Detector. When the pulse mode is activated the laser beams will
flash at a very high frequency (invisible to the human eye). This
will allow the detector to detect the laser beams.
1. The pulse mode can be activated both in Automatic and in
Manual mode.
2. Turn on the laser level (to the required mode).
3. Press the Pulse mode button (c) to activate it. The Pulse
mode indicator (d) will turn on. Visually, the intensity of the
beam will be a bit reduced.
4. Turn on the detector and search for laser beam.
5. You can choose a different beam, by pressing on the beam
selector button (a), while you are in Pulse Mode.
6. To switch the Pulse Mode off, press the Pulse mode button (c)
and the Pulse mode indicator (d) will turn off.
12
102494