Ironside Prolaser 3D All-Lines Mode D'emploi page 11

Working in Manual mode:
In Manual mode the 102494 self-leveling mechanism is disabled and the
laser beams can be set at any slope required.
1. Verify that the locking switch #1 is on the OFF position.
2. Press and hold the Manual mode button (a) for 3 seconds, to activate the
manual mode. The laser level will project a 360° horizontal beam
that will flash every 3 sec. to let you know that the beam is not
leveled. The beam indicator (b) will turn on.
3. To mark a slope, tilt the laser to the desired angle.
4. To choose another beam, briefly press the beam selector button
(a) - it will turn on a 360° vertical side beam instead of the horizontal
beam.
5. An additional click on the beam selector button (a) will add a 360°
forward vertical flashing beam.
6. One more click on the beam selector button (a) will switch on the
horizontal beam in addition to the vertical beams.
7. Next click on the beam selector button (a) will switch OFF all the
beams and the beam indicator (b) will turn off.
8. While in Manual mode, turning the locking switch #1 from OFF to ON
will turn off the Manual mode. The automatic self – leveling mode will
be activated (if the laser level is within the self – leveling range).
102494
11