Quick Reference; Software Upgrade - SELFSAT SNIPE DOME 2 Manuel Utilisateur

3-3. Quick reference

1. Turn on the remote control and select the unit that matches the MAC Address of your
antenna.
2. Use the left and right arrow buttons to select the satellite and press the SET button.
3. Wait for the message 'FOUND SAT' to appear on the remote control screen.
4. When the satellite search is complete, watch the broadcast.
NOTE
In order to ensure that your SNIPE DOME 2 works properly you must
ensure that it is following by the Operating Instructions in this manual
and used as intended purpose.
If the system cannot fully be removed due to user's negligence, then it is
your responsibility to check that the antenna is properly stored in safe.
Please also note that different legal requirements are applied to the
operation of electrical and electronic equipment in different countries.
As the user of this equipment, you are responsible for yourself ensuring
compliance with the relevant laws and regulations. The manufacturer
does not take liability for direct or indirect consequential damage of the
system, motor vehicles or other equipments by reason of unsuitable
battery usage or erroneous installation or wrong wire connection.

4. Software Upgrade

4-1. Upgrade via the app
a. Download and install the Sat Connect app from the App store
b. Turn on the antenna power (Turn on the receiver power and PI box)
c. Connected the application with the antenna
d. Select FW UPGRADE from the menu to update the antenna
e. UPGRADE takes about 5 minutes
ENGLISH - 11