Quick Start Guide (En) - Zotac ZBOX M Serie Guide D'installation Rapide

QUICK START GUIDE
PAC K AG E C O N T E N T S
• 1 x ZOTAC ZBOX
• 1 x Stand
• 1 x VESA mount
• 1 x AC Adapter
• 1 x Power Cord
• 1 x Warranty Card
• 1 x User Manual
• 1 x Driver disc
• 1 x USB drive with O/S driver
• 1 x Antenna
C U S TO M I Z I N G YO U R ZOTAC Z B OX
1. Lay the ZOTAC ZBOX on a flat surface with the rubber
feet facing upwards.
2. Locate the two thumb screws and remove.
3. Slide the cover off the ZOTAC ZBOX in the direction of
the arrow.
I N S TA L L I N G M E M O RY M O D U L E S
1. Locate the SO-DIMM memory slots and insert a SO-DIMM
memory module into the slot at a 45 degree angle.
(Note: If the ZOTAC ZBOX has two SO-DIMM slots insert a module
into the lower slot first)
2. Gently press down on the memory module until it locks
into place by the arms of the memory slot.
INSTALLING A HARD DISK
1. Locate the 2.5-inch SATA hard disk and the hard disk
bracket.
2. Install the hard disk to the hard disk bracket.
3. Insert the hard disk into the slot at a 45 degree angle
and gently slide into the connector.
4. Reinstall the thumb screw.
2
1
2
1
1
3 4
3
2
2