How To Install Tx-29 & Tx-30; Antenna Installation - Technaxx TX-29 Manuel D'utilisation

4.1 How to install TX-29 & TX-30
See figure 4-1 above and follow the steps below.
① Plug in the included USB mouse to one of the USB connector.
② Connect the output of the supplied 12V power adapter into the power socket on the
NVR.
③ Plug the power adapter into the wall socket.
④ Connect the output of the supplied 12V power adapter into the power socket on the
Camera.
⑤ Plug the power adapter into the wall socket.
Wait for a few minutes till the TX-29/TX-30 and the IP camera finished startup. So far, the
local surveillance system was done.
⑥ If you want to remote access this system with a Smartphone or computer, you should
connect the TX-29/TX-30 to your home wireless router with a RJ45 network cable and
make sure the router has been linked to internet. For Smartphone installation see chapter
6.3 Mobile application (Security Premium).

4.2 Antenna installation

Use a clockwise motion to connect the antenna. Make sure the antenna is connected firmly
but not excessively. You can adjust antenna horizontal or vertical direction to get best
reception.
Monitor Camera
7