Installation For 100-150 Cm; Forward Facing Position Isofix + Top Tether + Harness - Be Cool SUN Instructions

EN NOTICE: Seat padding. Padded waist support.
- For a child with a height of 76-80 cm only the seat
padding will be necessary.

3. INSTALLATION FOR 100-150 CM

Forward facing ISOFIX + top tether + harness.
1 . Open the seat belt buckle.
2. Lift the padding on the backrest.
3. Press the central adjustment button and pull the
harness.
4. Unlock the button and open the padding on the
backrest.
5. Store the shoulder padding and straps inside the
padding of the backrest.
6. Insert the fastener through the slot.
7. Store the harness away and remove the padded
waist support. Set the backrest to position 1
54
8. Seat the child in the car safety seat
9. Set the headrest to the correct height for the child
If the headrest is not at the correct height it is not
safe.
10. pass the 3-point seat belt through the correspon-
ding belt guides and check that the child's pelvis
is held comfortably but securely.
11. Pass the vehicle seat belt through the red locking
device
12. Tighten the seat belt after hooking it in the anchor
point and make sure it clicks into place. (Make
sure the seat belt is not twisted)
4. INSTALLATION FOR 100-150 CM
ISOFIX accessories in the forward facing position +
vehicle 3-point seat belt.
Read carefully the section referring to the Isofix
anchor points in the vehicle instructions (bear in