Astralpool WATERLIFT Manuel D'instructions page 35

Fault
Motor oil loss.
The lift does not turn on.
Whistling is heard, the
moving step does not
move, as if it did not
have enough power.
The moving step does to
reach its top position.
The lift stops for safety
reasons after moving for
approx. 2 seconds.
The moving step
suddenly stops on
reaching its top position
without slowing down.
The push-buttons do not
work.
Instruction Manual Waterlift rev.0.7 -06/09
Possible cause
Reducer catches are dry.
Main switch turned off.
Lack of power supply (230 V).
Failure in the electronic board.
Worn electric motor brushes.
It is a faulty lift.
Weight overload.
The moving step is blocked.
Failure in the electronic board.
Weight overload.
Weight overload.
Teeth counter optical sensor
fault.
Top end of travel optical sensor
fault.
Electric fault.
Maintenance
Solution
Contact the nearest distributor or
authorised technical service.
Check that all the switches
are in the on position.
Check the power supply.
Check the control board
power supply.
Contact the nearest
distributor or authorised
technical service.
Try the lift without weight.
Check the condition of the
pulling cable.
Change the step bearings.
In the event of an electronic
board failure, contact the
nearest distributor or
authorised technical service.
Try the lift without weight and
then with weight (always
under 140 kg).
Check the power supply.
Contact the nearest
distributor or authorised
technical service.
Try the lift without weight.
Contact the nearest
distributor or authorised
technical service.
Contact the nearest distributor or
authorised technical service.
Contact the nearest distributor or
authorised technical service.
35/196