Setup; Step 1-Connect The Wt-2 - Nikon WT-2 Mode D'emploi

Setup

Step 1—Connect the WT-2
1
Turn the camera off.
2
Remove the cover protecting the camera power
contact. The cover can be stored in the housing
on the WT-2.
3
Place the camera on the WT-2 and rotate the knob
in the direction shown to fasten the WT-2 to the
camera tripod mount.
4
Open the camera USB connector cover and con-
nect the USB cable to the USB connector.
5
Pass the cable over the guide on the BL-2 battery-
chamber cover.
Disconnecting the WT-2
To disconnect the WT-2:
1 Turn the camera off.
2 Disconnect the USB cable.
3 Rotate the knob clockwise to unscrew the WT-2 from the camera tripod mount.
4 Replace the cover on the camera power contact.
4