Stopping The Tool; Troubleshooting; Improper Uses; Tool Transport - CAMPAGNOLA HERCULES Manuel D'utilisation Et D'entretien

Stopping the tool

The tool must always be switched off at the end of the work season.
All information about using and operating the tool can be found in the use and maintenance manual of the chosen power
unit.

Troubleshooting

WARNING!
All extraordinary maintenance operations must be carried out by a mechanical or electrical / elec-
tronic maintenance technician.
FAULT
Mechanical head overheating
Anomalous rake (2) vibrations
The tool does not work
The tool is not powerful enough
Temporary tool stopping during its
use
IMPORTANT: If the above-mentioned remedies do not solve the problem, contact an Authorised Service Point.

Improper uses

- Never use the tool when your balance is unstable.
- Never use the tool as a lever or for lifting, moving or breaking any objects.
- Never use the tool if the atmosphere is explosive or inflammable.

Tool transport

In case of long transports keep the tool in its packaging.
WARNING !
Use the tool only for the purposes described in par. "Product Description". Any other use can cause injuries
and damages.

6 MAINTENANCE

Routine maintenance

WARNING!
• Before any routine maintenance operations, if the harvesting head is assembled on the tool, switch the
harvester off (read the power unit manual), disconnect the power supply cable and then remove the head
from the extension pole (11-12).
• All maintenance operations which are not described in this manual shall be carried out only by an Authorised
Service Point.
Routine maintenance operations can be carried out by the operators.

General

Before any routine maintenance operation:
• Select the OFF mode of the power unit switch.
• Wear protective gloves.
• Disconnect the harvesting head from the extension pole (11-12).
Pag. 20
CAUSE
Dirt and/or wear and tear of the
inner rotating parts.
• Rotating parts wear and tear.
• Wrong tightening of the rake fi-
xing screws (6).
Flat battery.
Falt battery.
• Motor overheating due to thick
branches.
• Exceeded current limits.
REMEDY
Carry out the mechanical head cleaning and
maintenance operations.
• Carry out the mechanical head cleaning and
maintenance operations.
• Tighten the screws (6).
Recharge the battery (read the power unit man-
ual).
Recharge the battery (read the power unit man-
ual).
Get out of the tree, wait for few seconds and then
start the tool again by means of the ON-OFF
switch (read the power unit manual).
Use and maintenance manual – Translation of
original Instruction Ver.1.0 - Rev.: 02, Date : 25/01/2022