Replacing The Teeth; Cleaning And Greasing The Harvesting Head; Storing The Tool; Special Maintenance - CAMPAGNOLA HERCULES Manuel D'utilisation Et D'entretien

Replacing the teeth

The damaged teeth (1) have to be removed from their seat:
• Disassemble the teeth holder (7) by removing the 4 screws (6).
• Put the teeth holder (7) onto a surface and shorten the damaged teeth (1) 2 cm away from the holder.
• By means of a rubber hammer hit the top of the tooth (1) till it gets out of its seat.
• Put the new tooth (1) into its seat, being careful to hook the small plastic protrusion to the teeth holder (7) side.
• Re-assemble the rake (2) onto the oscillator (8).

Cleaning and greasing the harvesting head

Every 200 work hours, open the mechanical head and remove any dust and dirt inside of it. Check the anti-rotation
drives (10) condition and add Campagnola LISYNT-00-EP spray grease.
WARNING!
Cleaning the harvesting head allows to limit frictions, which would jeopardize tool performance and work
autonomy.

Storing the tool

Before storing the tool for a prolonged period, carry out the following operations:
• Take the harvesting head to a Campagnola Authorised Service Point for being cleaned and greased.
• Store it in its box in a dry place.
WARNING!
During use, if the fixing ring of the extension pole (/) is loose, stop working immediately. Keep the trigger (4)
pressed to close the blade, and then tighten the extension pole locking ring (14).

Special maintenance

WARNING!
Any special maintenance operation, such as the replacement of the gear motor or of the main boards, must be
carried out at an Authorized Service Point.
AUTHORIZED SERVICE POINT
It is the Service Point authorized by the Manufacturer for repairing the products.

Maintanance table

Maintenance
Check the screws for proper tightening
Clean the harvesting head and lubricate the anti-
rotation drives with Campagnola LISYNT-00-EP
spray grease
Thorough overhoul by a Campagnola Authorised
Service Point
Use and maintenance manual – Translation of
original Instruction Ver.1.0 - Rev.: 02, Date : 25/01/2022
After the first 8 After 200 work
work hours hours
X
At the end of every work
season and/or every 400
work hours
X
X
Page 21