Makita BTP130 Manuel D'instructions page 6

ENGLISH
1 Button
2 Red part
3 Battery cartridge
4 Switch trigger
5 Lamp
6 Reversing switch lever
7 Action mode change lever
8 Adjusting ring
9 Graduation
10 Pointer
SPECIFICATION
Impact driver mode
Hammer drill mode
Drill mode
Screw driver mode
Overall length
Net weight
Rated voltage
• Due to our continuing program of research and devel-
opment, the specifications herein are subject to change
without notice.
• Note: Specifications may differ from country to country.
Intended use
The tool is intended for impact screw driving in wood and
for impact drilling in brick, concrete and stone as well as
for drilling and screw driving without impact in wood,
metal, ceramic and plastic.
Safety hints
For your own safety, please refer to the enclosed safety
instructions.
6
Explanation of general view
11 Bit
12 Sleeve
13 Bit-piece
14 Hook
15 Screw
16 Groove
17 Standard bolt
18 Fastening torque
19 Proper fastening torque
20 Fastening time
Model
Max. fastening torque
Capacities
–1
No load speed (min )
Impacts per minute
–1
No load speed (min )
Blows per minute
Capacities
–1
No load speed (min )
Capacities
–1
No load speed (min )
Capacities
Machine screw
Standard bolt
High tensile bolt
Concrete
High (2)
Low (1)
Steel
Wood
Machine screw
SPECIFIC SAFETY RULES
DO NOT let comfort or familiarity with product
(gained from
adherence to 4 mode impact driver safety rules. If
you use this power tool unsafely or incorrectly,
you can suffer serious personal injury.
1. Hold power tools by insulated gripping surfaces
when performing an operation where the cutting
tool may contact hidden wiring or its own cord.
Contact with a "live" wire will make exposed metal
parts of the tool "live" and shock the operator.
2. Always be sure you have a firm footing.
Be sure no one is below when using the tool in
high locations.
3. Hold the tool firmly.
4. Keep hands away from rotating parts.
21 High tensile bolt
22 Limit mark
23 Rear cover
24 Screws
25 Spring
26 Arm
27 Recessed part
28 Carbon brush cap
29 Hole
BTP130
135 N•m
4 mm – 8 mm
5 mm – 14 mm
5 mm – 12 mm
0 – 2,400
0 – 3,200
0 – 2,400
0 – 28,800 0 – 27,600
8 mm
0 – 2,400
0 – 700
10 mm
21 mm
0 – 2,400
M4
186 mm
1.7 kg
D.C. 14.4 V
repeated use)
BTP140
145 N•m
0 – 2,300
0 – 2,300
0 – 2,300
0 – 2,300
1.8 kg
D.C. 18 V
GEB026-1
replace strict