Publicité
Les langues disponibles
Les langues disponibles
5. Install tube clamp (A2) using fasteners (B3 and B2). Do
not tighten completely at this time.
6. If winch is not already installed on mount, install now using
the fasteners supplied in winch kit.
7.
Place winch mount into position. Temporarily place
fasteners (B3) into top side location of mount to hold winch
mount into position.
NOTE:
Make sure that when the mount is installed on the
vehicle, the winch motor will be facing vehicle left.
8. Reinstall backing plate with fasteners removed in step one.
Leave loose to allow winch mount to be adjusted.
NOTE:
Follow instructions found in winch kit for complete
winch mount installation instructions.
©2012 Warn Industries, Inc. WARN® and the WARN logo are trademarks of Warn Industries Inc.
Tube clamp
Fasten backing plate
5
fasteners
Figure 5
Figure 6
B2 and B3
Figure 7
Figure 8
91256A0
Publicité
