Publicité
Les langues disponibles
Les langues disponibles
warning:
always use safety glasses. Everyday eyeglasses are NOT safety
glasses. Also use face or dust mask if drilling operation is dusty. ALWAYS WEAR
CERTIFIED SAFETY EQUIPMENT:
• ANSI Z87.1 eye protection (CAN/CPA Z94.3),
• ANSI S12.6 (S3.19) hearing protection,
• NOSH/OSHA respiratory protection.
warning:
use of this tool can generate and/or disperse dust, which may
cause serious and permanent respiratory or other injury. Always use NIOSH/OSHA
approved respiratory protection appropriate for the dust exposure. Direct particles away
from face and body.
caution:
wear appropriate hearing protection during use. Under some condi-
tions and duration of use, noise from this product may contribute to hearing loss.
•
When using an extension
cord, be sure to use one heavy
enough to carry the current
your product will draw. An
undersized cord will cause a
drop in line voltage resulting in
loss of power and overheating.
The following table shows the
correct size to use depending
on cord length and nameplate ampere rating. If in doubt, use the next heavier gage. The
smaller the gage number, the heavier the cord.
syMBols
• The label on your tool may include the following symbols. The symbols and their
definitions are as follows:
V ..................volts
Hz ................hertz
min ..............minutes
............direct current
................Class I Construction
(grounded)
................Class II Construction
(double insulated)
.............Read instruction manual before use
................Use proper eye protection
sfpm ............ surface feet per minute
functional description
1. Trigger switch
2. Lock-on button
3. Saw blade locking lever
4. Saw blade
5. Blade guide roller
6. Shoe
7. Speed control wheel
8. Cutting action lever
9. Vacuum adaptor
10. Hex wrench
Minimum gage for cord sets
volts
120V
0-25
(0-7,6m) (7,6-15,2m) (15,2-30,4m) (30,4-45,7m)
ampere rating
More Not more
Than Than
0 -
6
18
A ...................amperes
W ..................watts
................alternating current
n o .................no load speed
.................earthing terminal
.................safety alert symbol
.../min ..........revolutions or reciprocation
................ Use proper respiratory protection
.................Use proper hearing protection
7
3
4
total length of cord in feet
26-50
51-100
American Wire Gage
16
16
per minute
2
1
8
6
5
4
101-150
14
10
9
Publicité
