GM Racing 7152 Instructions D'utilisation page 12

Instruction Manual PROGRAMMER Order-No. 7152 for GM-GENIUS RACE 40R, 80R Order-No. 7154 - 7157
Product appearance
Opening screen
Connect the programmer to the BEC of the ESC or additional power, the following screen is shown for 1
seconds.
CAR Brushless
Programmer V1.00
The screen below is shown for 10 seconds until the SETUP CARD is properly connected to the ESC.
Connecting..
0 Sec
The major two functions on this programmer are as like:
1. The programmer can read the data inside the ESC so that it can allow user to modify the data ( if
wanted ) and store the revised data at the programmer.
Note: If the programmer is NOT connected to the ESC for 10 seconds, the below screen is shown. In this
case,
pls retry to connect the programmer to the ESC.
2. If the programmer has the same data which is also stored at the ESC, user can change some
data in the programmer while actually using the ESC, then those revised data can be stored at
the programmer and those revised data can be sent out to the ESC at one time.
Note : to use the programmer for the purpose of this function without connecting the ESC, if any button is
pressed within 10 seconds, the below screen is shown then if any button is again pressed, you are now
ready to change any parameters that you wish.
Car Brushless
Programmer V1.00
Up
Dec
Down
Inc