Arexx BS-30 Utilisation page 19

2. Troubleshooting
The USB sensor but fails to registrate.
Potential problems:
- Accu is empty or are at a low level
- PC does not registrate the BS30
Potential causes:
- USB is not properly connected to the PC
- USB driver is not installed corectly
E
- Unknown software or driver problem
N
Suggested solutions:
- Fully charge the accu in the USB sensor (see charge LED).
G
- Check the "Synchronisation" window in the temperature
L
logger software. The field is to display the value 'USB@x'
and the version number.
I
- Remove the USB sensor wait for 10 seconds and connect it again.
- Deinstall the Multiloggerlogger Software and do a reinstallation
S
with the latest versions. (see www.arexx.com)
H
wiederholen Sie die Installation.
-
Check the sensor list if the sensornumbers are available
Charge LED (Red)
LEDS
AND
SWITCHES
Measure LED (Blue)
19
Reset
PGM