LENCO LBT-188 Guide D'utilisation page 12

3 - 3.5g
3.5 - 4g
Slip the loop of the anti-skating weight's thread over the 3rd groove of the
stub to set the correct anti-skating force for the factory-fitted cartridge. Feed
the thread through the loop of the wire support.
Stereo System connection
RCA Jacks
· The RCA Jacks of this unit are shared as both the Phone output jacks and the
Line output jacks. They are determined by the Phono/Line Switch.
· When used as a line output, the jacks output analog line-level signals and
could be connected directly with a pair of active speakers or the appropriate
input of your stereo system. When used as a Phono output, they should be
connected to the phono pre-amplifier or the phono input of the stereo
system.
· The Red plug connects with the Right channel and the White plug connects
with the Left channel.
Note:
· If the Phono/Line switch is set at LINE position but RCA jacks connected to
the stereo system's phono input, the sound might be distorted due to input
overload and could damage your stereo system.
· If the Phono/Line switch is set at PHONO position but RCA jacks connected
to the stereo system's line input, the volume will be very low due to lacking
signal pre-amplification.
RCA Jack is not designed to be connected directly to the passive/unpowered
speakers and if it does, the volume will be very low.
rd
3 " " "
4 th " " "
11