LENCO LBT-188 Guide D'utilisation page 11

2. Pull the anti-skating weight slightly to let the tie of the fishing line move
to the stub.
3. Lift the anti-skating weight over the anti-skating weight wire support.
The anti-skating weight should now be dangling in free space to the left
of support.
Slip the loop of the anti-skating weight's thread over the 3nd groove of the
stub to set the correct anti-skating force for the factory-fitted cartridge. Feed
the thread through the loop of the wire support.
Anti-skating force adjustment
The anti-skating force must be adjusted corresponding to the down force as
follows:
Down force
2 - 2.5g
2.5 - 3g
Groove in the stub
1 st from bearing rings
2 nd " " "
10