Overview Of Modes; Cooling Mode (Cool); Smart Mode; Fan Mode (Fan) - Noaton AC 5109 Mode D'emploi

Inserting battery (battery is included in the pack)
When you first use the device it is necessary to remove the protective plastic cover
from the battery.

Overview of modes

Cooling mode (COOL)

When room temperature is higher than the required temperature, the compressor will run and the air
will be cooled. If room temperature is lower than the target (as set by the user), the fan will continue
to run but the compressor will be switched off. The pilot light on the control panel beside the
inscription COOL will flash [Note: just like when you switch the machine off and back on again the
cooling circuit does not start for 3 minutes in order to protect the compressor ].
Cooling does not work at temperatures under 15°C or above 43°C.

SMART mode

In the 22–24°C range or below, the unit only uses the fan; above that threshold temperature, the
cooling circuit of the appliance is activated and therefore the air conditioner works in cooling mode.
In this mode it is not possible set the required target temperature, although the fan speed can be
adjusted.

Fan mode (FAN)

In this mode you can switch between fan speeds, but the compressor will not work.
It is not possible to set the temperature.
41