Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2. Fill in liquid and soft ingredients first then firmer ingredients into the jar and put the lid on
with measuring cup.
3. Turn the knob to the desired level.
4. You can take of the measuring cup of the lid and add other ingredients. Add water as
desired.
5. Mix the ingredients until the desired consistency is reached and then turn off the device.
6. Wait until the motor has completely stopped before you take the jar.
15.3.1 Pulse function
Use the pulse function for short and powerful blending.Turn the knob to the left side to the
pulse function and hold it. As long as you hold the knob in this position the pulse function
is working. Use this function only in short intervals.
15.3.2 Crushing of ice
Fill the jug with ice cubes.
Turn the knob for a few seconds to the left side for using pulse function.
► This device must not idle nor be overfilled, because the motor will overheat and gets
damaged.
► Do not leave the device unsupervised when it is in operation.
► Remove power plug first before pouring out the food.
For your own safety:
Never operate the device without the original lid that is part of delivery scope. In addition
do never put your hand into the blender jug/jar during operation.
15.4 Overheat protection
In order to prolong the device's service life, an overheat protecting unit is installed. If the
motor runs too long or overloaded, the temperature reaches the warning value and the
motor will stop automatically. Pull out power supply plug and wait for the motor to cool
(about 30 minutes), then you can use it again.
If you have any problem with this device, do not disassemble it by yourself. Always contact
the service department or after-sale service department.
16 Cleaning and Maintenance
This chapter provides you with important notices with regard to cleaning and maintaining
the device. Please observe the notices to prevent damages due to cleaning the device
incorrectly and to ensure trouble-free operation.
Please note
Warning
32
Publicité
Table des Matières
Dépannage
