Safety Information; Cleaning; Replacement Of The Extra Gear; Troubleshooting - CASO DESIGN B 2000 Mode D'emploi

16.1 Safety information

Please observe the safety instructions, before cleaning your device
► Unplug the can opener when not in use and before any cleaning.
► Never immerse the can opener, cord or plug in water or other liquids and do not place in
the dishwasher.
► The blades are really sharp. Handle them with care.
► Do not use any aggressive or abrasive cleaning agents or solvents.
► Do not scrape off stubborn dirt with hard items.
► No cleansing agents (except liquid soap), scouring pads or metallic brushes must be
used as the surface of the device could be damaged.
► Do not use solvent-based cleaners such als gasoline to avoid damaging the plastic
parts.

16.2 Cleaning

Do not clean the motor housing with water. Remove the insulation pad. Wipe motor
housing and insulation pad with a slightly damned cloth.
Clean all components (pusher, lid, measuring cup), which come into contact with food, with
a mild soap solution and rinse them afterwards with water. Allow all components to dry
before you reassemble them.
Cleaning of the jar
Remove all the ingredients from the jar and fill with warm water a little detergent. Blend
this mixture at the highest level for 30 seconds. Spill out the detergent mixture and pour in
fresh water. Mix for 30 seconds at the highest level. To remove stubborn dirt, repeat this
cleaning.

16.3 Replacement of the extra gear

Two extra gears are delivered with the device.
1. Use pliers to remove the original gear.
2. Press down the extra gear
3. Check that the extra gear is placed on same level as the motor driver gear.

17 Troubleshooting

This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:
Attention
33