Gartenmeister GM-HM 20 Mode D'emploi page 22

GB
ENGLISH
Before using, always visually inspect to see that the
blades, blade bolts and cutter assembly are not blunt,
worn or damaged. Replace worn or damaged blades and
bolts in sets to preserve balance;
Do not use the appliance if you are tired, ill, under influ-
ence of drugs, alcohol drinks or medicaments.
Do not overreach. Keep proper footing and balance at all
times. Be careful when going backwards – risk of tripping!
Provide adequate lighting or good lighting conditions
when working with the machine. Poor lighting/light
conditions represent a high safety risk.
Avoid operating the equipment in wet grass, where
feasible;
Walk! Never run!
Make sure your posture is safe, especially on slopes. Do
not cut on too steep slopes. Be particularly careful when
changing travelling direction on slopes.
Always operate rotary machines with wheels at a right
angle to the slope and not up and down.
Pay maximum attention when turning around and pulling
the appliance to you.
WARNING
Risk of injury
Rotating blades may lead to serious injuries by cutting
or amputating parts of the body.
• Switch the cordless one-hand-mower off whenever
carrying or inclining it or when being outside a grass area.
Wait until all rotating parts have stopped.
• All protection covers and safety devices must be correct-
ly attached to operate the device.
• Do not start the engine before your feet are in a safe
distance from the cutting tools.
• Do not incline the appliance when being started.
• Do not start the appliance when you are standing in front
of the ejection opening.
• Never touch under the housing body when the engine
is running. Keep a distance from the ejection opening
at all times.
• Avoid accidental starting. Always be in the start position
when you press the start button.
• All work / settings on the machine may only be
carried out with the engine switched off, the plug
disconnected and with the mower blade at a
standstill.
WARNING
Risk of injury
Thrown-off stones or soil may lead to injuries.
• Before mowing, check the area to be mowed for any
undesirable objects.
• Wear safety goggles when working.
Stop the machine and take out the contact key. Wait
until all rotating parts have stopped and the unit has
cooled down. Take out the key.whenever you leave the
lawnmower -
20
• To release a blocked blade.
• Clean the mower or do any other works before checking
the mower.
• Check the machine if working perfectly after catching
an undesirable object. Repairs must be executed before
putting the machine into operation again..
If the appliance starts abnormally vibrating, switch the
engine off and search for the cause immediately. General-
ly, vibrations are a warning against operating failure.
The appliance must not be used if damaged or safety
equipment is defective. Replace any worn-out and
damaged parts.
The ON/OFF switch and safety switch must not be locked.
When working with this machine, do not use spare parts
other than those recommended by us. Using spare parts
not recommend by us can result in serious injuries to
persons or damage to the machine.
Despite the observance of the operating instructions
there still may be some hidden residual risks.
CAUTION
Damage to health arising from vibrations to hand
and arms if the device is used for a long time or if the
device is not guided and evaluated properly.
Vibration damping systems are no guaranteed protection
against white finger disease or carpal tunnel syndrome.
Therefore, it is necessary to carefully check the state of
your fingers and wrist if you have regularly used the appli-
ance for a long time. If any symptom of the diseases above
appears, seek medical advice immediately. To reduce the
white finger disease risk, keep your hands warm and take
regular breaks during your work.
CAUTION
Hearing damage
A longer stay in the immediate vicinity of the running
unit may cause hearing damage. Wear ear protectors!
When working with the device, a certain level of
noise cannot be avoided. Noisy work should be
scheduled for hours, during which it is allowed by
statute or other local regulations. Adhere to any
applicable rest times and limit your working time to
the necessary minimum time.
For your personal protection and the protection of people
nearby, suitable hearing protection must be worn.
Noise emission information in accordance with the
German Product Safety Act (ProdSG) and the EC Machine
Directive: the noise pressure level at the place of work can
exceed 80 dB(A). In such cases the operator will require
noise protection (e.g. wearing of ear protectors).
Please do also consider any local regulations concerning
noise protection!