Scotts LSS10272PS Manuel De L'utilisateur page 6

CHARGING PROCEDURE
1. Insert the charger cable into the charging inlet
on the tool.
2. Make sure the wall outlet in your home is normal
household voltage (AC120V, 60 Hz). Insert the
battery charger plug into the wall outlet.
3. The red LED (A) charging indicator lights up to
tell you that the battery pack is on charge. The
battery is fully charged when the red LED
charging indicator is no longer lit.

During the charging process, it is normal for
the handle of the tool to warm up.

When not using the tool for extended periods,
disconnect the battery charger from the socket.

When the trimming shears are charging, you
must not use them.

Only charge the battery between 0°-37.8°C
(32°-100°F).

After prolonged use, allow the battery to cool
down before recharging.
ADJUST THE LENGTH OF TELESCOPIC HANDLE
1) Loosen the handle connector (6)
2) Pull the tube out to increase the height, or
push the tube in to decrease the height.
3) Re-tighten the handle connector (6)
GENERAL INSTRUCTIONS
A
6
Model LSS10272PS
STARTING AND STOPPING
Starting:
1. Push the safety lock button and press the
on/off trigger switch at the same time.
2. Release the safety lock button.
Stopping:
1. Release the on/off trigger switch.
OPERATING INSTRUCTIONS
This product is intended for light trimming of
shrubs, hedges and lawn edges. Please note that
this tool is not designed for commercial, trade,
or industrial use. Only use this product for the
purpose specified in these instructions. Any other
use will void the warranty.
GRASS CUTTER BLADE
Use the grass cutter blade for cutting the edges of
lawns and small areas of grass in private gardens
and hobby areas.
The grass cutter blade is not intended for cutting
hedges of chopping material up for composting.
Edging
Guide the tool along the edge of the lawn.
After use install the blade guard.
Tips:
− Do not force the unit through dense growth, and
if the blades slow down, reduce your speed.
− Avoid trimming too close to dirt, sand or gravel,
as this could dull the blades and reduce the
cutting efficiency.
− Do not allow the blade to contact paved surfaces,
stones or garden walls, as this will rapidly wear
down the blade.
SHRUB TRIMMING BLADE
Use the shrub trimming blade for trimming and
shaping individual bushes, shrubs, and climbing
plants in private domestic and hobby gardens.
The shrub trimming blade is not intended for cutting
grass / edging.
Cutting shrubs

Before using, check the shrubs for foreign
objects e.g. wire, etc.

When using the tool hold it away from yourself
and stand in a secure position with your weight
evenly balanced on both feet.

When cutting, move steadily along the line of
cut, so that stems are fed directly into the cutter
blades.

After use, install the blade guard.