R100 Remote Control - Grundfos MAGNA 2000 Serie Notice D'installation Et D'entretien

8.2.2 Setpoint setting
Set the setpoint of the pump by pressing
when the pump has been set to proportional-
pressure control, constant-pressure control or
constant-curve duty.
The light fields, pos. 5, on the control panel indicate
the setpoint set.
MAGNA 40-120, 65-120
The light fields can indicate a maximum setpoint of
10 corresponding to 32 feet (10 m).
Fig. 15 Light fields MAGNA xx-120
MAGNA 65-60
The light fields can indicate a maximum setpoint of
5 corresponding to 16 feet (5 m).
Fig. 16 Light fields MAGNA 65-60
8.2.3 Setting to max. curve duty
Description of function, see section 7.5 Max. or min.
curve duty.
To change over to the max. curve, press
continuously until "MAX" illuminates, see fig. 17. To
change back, press continuously until the desired
setpoint is indicated.
Fig. 17 Max. curve
16
8.2.4 Setting to min. curve duty
or Description of function, see section 7.5 Max. or min.
curve duty.
To change over to the min. curve, press
continuously until "MIN" illuminates, see fig. 18. To
change back, press
setpoint is indicated.
Fig. 18 Min. curve
8.2.5 Start/stop of pump
To stop the pump, press
"STOP" illuminates. When the pump is stopped, the
green indicator light will be flashing.
To start the pump, press
If the pump is to be stopped, it is
recommended to use the start/stop
input, the R100 or to switch off the
Note
electricity supply. In this way, the
setpoint will remain unchanged when
the pump is started again.
8.2.6 Resetting of fault indications
The fault indications are reset by briefly pressing
any button. The settings remain unchanged. If the
fault has not disappeared, the fault indication will
reappear. The time until the fault reappears may vary
from 0 to 255 seconds.

8.3 R100 remote control

The pump is designed to communicate with the
Grundfos R100 remote control via infra-red light.
During communication, the R100 must be pointed at
the pump control panel. When the R100 is
communicating with the pump, the red indicator light
will flash rapidly.
The R100 offers additional possibilities of setting and
status displays for the pump.
continuously until the desired
continuously until
continuously.