Viscount Chorale 8 Mode D'emploi page 49

Owner's Manual
2.4 THE SWELL PEDALS
The bottom part of the organ, above the pedal board, contains the swell pedals.
1. [CRESCENDO] pedal: you can use this pedal to select the Crescendo steps which activate a preset
series of stops. The step currently selected is displayed by the [CRESCENDO] LED bar on the central
panel (see also point 2.1, subsection 3).
Each Crescendo step is programmable. To do this, use the [CRESCENDO] pedal to select the step
you require, switch on the voices and couplers of your choice, press [S], keep it pressed and then
press the general memories [HR] button.
2. [MAN. I] Swell Pedal: swell pedal used to regulate the volume of the first manual.
3. [MAN. III] Swell Pedal: this swell pedal is used to regulate the volume of the third manual.
This swell pedal also incorporates a special lever system for control of the Sustain effect for the Orchestra
voices (except the Pedal voices).
N.B.
The display volume controls which can be displayed by pressing the [VOL.] button allow balancing
of the sections; once you have set the levels best suited to your taste and the sound balance you
require, they will not require frequent adjustment.
The swell pedals, on the other hand, allow continuous control of the volumes, enabling you to
obtain all the dynamic effects you wish. Apart from regulating the volume, the swell pedals also
simulate the variation in timbre of the stops which would occur in the swell boxes of pipe organs.
1 2 3
47
Chorale 8
Viscount