Publicité
Les langues disponibles
Les langues disponibles
Total Reset
General reset operation erases memories, access code and will return all settings
to factory settings (see « SETTINGS PROGRAMMING » section pages 28-30).
1) Make sure the telephone is connected to a powered C.O. or PBX line.
2) Depress « RESET » key (On the small keypad located at the back of the unit).
3) While keeping « RESET » key depressed, pick-up the handset.
4) 2 sharp « beep » tones will be heard.
5) Release « RESET » key.
6) Enter general reset code on the keypad: « 1-5-9 ».
7) If the right code is entered, 2 sharp « beep » tones will be heard (Don't hang up
the handset).
8) Wait several seconds until 3 « beep » tones can be heard, confirming the
general reset operation.
9) Hang up the handset.
Securphone
NOTE:
in emergency mode if a "Total Reset" is done.
Setting access code:
Setting choice:
Partial reset
Partial reset operation will return almost all settings to factory settings, but the 4
digits programming access code as well as all numbers stored into memories will
be saved (see « LIST OF SETTINGS » section pages 29-30).
Heating resistor
Securphone
The
moisture problems. This feature must be powered with the DC adaptor provided
in the pack. Connect the wires from DC adaptor as follows:
Urgence (Emergency) model needs to be re-programmed
04
Urgency: 1
offers the possibility to use an internal heating resistor to avoid
Heating resistor power
24 Volts DC/AC 50Hz 35
mA
Publicité
