Publicité
M.-Nr. 11763770
Danger due to incorrect service and repair work
WARNING
Danger due to incorrect service and repair work
There is a risk of serious damage, injury and even death if service and repair work is carried out incorrectly.
A
Service and repair work should only be carried out by a suitably qualified electrician with specialist training,
knowledge and experience.
A
All appropriate safety requirements must be taken into account.
A
Wear personal protective equipment.
A
First read the Miele service documentation, then commence work.
The "Miele Service Documentation (MSD)" service application is required when carrying out maintenance work
on the appliance
The safety instructions and warnings in the Miele Service Documentation (MSD) for the corresponding model must be
observed.
Work on the appliance must be carried out in accordance with the work instructions.
Attaching the XCI box with holding plate to the washing machine
A
Screw the fixing plate bracket (1) to the holding plate (3) with 2 M4 raised-head screws (2), see Fig. 1.
A
Screw the 2 cheese-head screws loosely to the holding plate with 1 washer and 1 nut attached to each of them,
see Fig. 2.
A
Remove the screws (1) from the lid of the XCI box, see Fig. 3.
A
Fold the lid of the XCI box up and back.
A
Position the top of the XCI box on the screws on the holding plate, see Fig. 4.
A
Screw the bottom of the XCI box to the holding plate using the 2 cheese-head screws with 1 washer and 1 nut
attached to each of them, see Fig. 4.
A
Screw the nuts tight at the top.
A
Remove the 3 screws from the rear of the washing machine, see Fig. 5.
A
Use the 3 screws you removed above to screw the XCI box to the rear of the washing machine, see Fig. 6.
A
Connect the XCI box as described in the operating instructions.
A
Fit the lid to the XCI box.
en
cs
Montážní návod pro XCI Box PWM12-20kg
Obsažené díly
Počet
č. m.
Název
1
XCI Box
1
plechový držák XCI Boxu
1
upevňovací plechový úhelník
4
šroub s válcovou hlavou M4 x 16
4
šestihranná matice DIN 934 M4 GAL/ZN
4
podložka M4 A2
5
šroub s čočkovou hlavou M4 x 12,5 (jsou potřeba jen 2)
Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Umbau- und Montageanweisung
9 von 20
12.05.2021
Publicité
