Publicité
M.-Nr. 11819250
en
Installation instructions for XCI box 2 PWM12–20 kg
Included parts
No.
Mat. no.
Designation
1
XCI box
1
Wiring harness for XCI box 2
2
Raised-head self-tapping screw 2.9 x 16
4
Cheese-head screw M4 x 16
4
Hexagon nut DIN 934 M4 GAL/ZN
4
Washer M4 A2
5
Raised-head screw M4 x 12.5 (only 2 are required)
Danger due to incorrect service and repair work
WARNING
Danger due to incorrect service and repair work
There is a risk of serious damage, injury and even death if service and repair work is carried out incorrectly.
A
Service and repair work should only be carried out by a suitably qualified electrician with specialist training,
knowledge and experience.
A
All appropriate safety requirements must be taken into account.
A
Wear personal protective equipment.
A
First read the Miele service documentation, then commence work.
The "Miele Service Documentation (MSD)" service application is required when carrying out maintenance work
on the appliance
The safety instructions and warnings in the Miele Service Documentation (MSD) for the corresponding model must be
observed.
Work on the appliance must be carried out in accordance with the work instructions.
Installing the wiring harness
A
Remove the cap (1) from the rear of the machine, see Fig. 1.
A
Feed the wiring harness through the opening and into the machine.
A
Use 2 raised-head self-tapping screws 2.9 x 16 to secure the Wepol coupling of the wiring harness to the rear panel.
A
Lay the new wiring harness parallel to the wiring harness for the existing Wepol coupling.
A
Plug in the earthing connection for the wiring harness next to the earth terminal on the wiring harness for the existing
Wepol coupling.
A
Connect the wiring harness on the electronic unit EL as shown in the wiring diagram.
Attaching the XCI box 2 with holding plate to the washing machine
A
Screw the fixing plate bracket (1) to the holding plate (3) with 2 M4 raised-head screws (2), see Fig. 2.
A
Screw the 2 cheese-head screws loosely to the holding plate with 1 washer and 1 nut attached to each of them,
see Fig. 3.
A
Remove the screws (1) from the lid of the XCI box, see Fig. 4.
A
Fold the lid of the XCI box up and back.
A
Position the top of the XCI box on the screws on the holding plate, see Fig. 5.
Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Umbau- und Montageanweisung
10 von 24
12.05.2021
Publicité
