Bellman & Symfon BE1441 Manuel D'utilisation page 40

Battery backup
Getting started
 Remove the battery slip on the
bottom of the unit before use.
 Please charge the unit for 24
hours to ensure full backup time.
Replacing batteries
(Done by the operator only)
Remove the screw on the bottom of

the unit to exhange the batteries.
78
BE1442
Caution
Risk of explosion if battery is replaced
by an incorrect type.
Dispose of used batteries according
to the instructions in this user manual.
Use only 4x1.2VNiMH

600AAA/900AAA Lexel
rechargeable batteries to
ensure full backup time.
Advanced programming
By using advanced programming, you can customize the signal pattern from a specific transmitter
and event, displaying the LED colour and vibration pattern of your choice. The advanced
programming overrides the radio key and pairs the units via the serial number.
Please note
 Smoke- and CO alarms cannot be programmed for safety reasons.
 The transmitter must be activated as it is intended to be used in the system to generate the
right signal. This means that you can't always use the transmitter test button (see
pattern
for the relevant transmitter).
Here is how you program the receiver:
1 Press and hold the mute/test button on the receiver. The green and yellow Visit LEDs will start
to blink alternately. While still holding down the button, activate the desired transmitter as
intended. Release the button.
2 Scroll through the different Visit LED options
Select the desired Visit LED colour by holding down the mute/test button until the power LED
goes out and lights up again.
3 Scroll through the different vibration options
shaker required). Select the desired vibration pattern by holding down the mute/test button
until the power LED goes out and lights up again.
4 The receiver will now show the new Visit LED colour and vibration pattern. Press the mute/test
button briefly to end the demonstration. After a short while, it will return to normal mode.
Deleting the advanced programming
Follow the procedure below to delete the advanced programming.
1
Hold down the mute/test button on the receiver until the green and yellow Visit LEDs blink
alternately. Release the button.
2
Press the mute/test button on the receiver 3 times in quick succession.
3 All Visit LEDs will light up for ~2 seconds to show that it has been deleted.
Default signal
by pressing the mute/test button on the receiver.
by pressing the test button on the receiver (bed
App
79