Bellman & Symfon BE1441 Manuel D'utilisation page 11

Read this first
This booklet guides you on how to use and maintain your new Visit flash receiver. Ensure you read this
booklet carefully, including the Warnings
you have additional questions, contact your hearing care professional.
Intended purpose The intended purpose of the Visit system is to alert deaf and hard of hear-
ing people of important signals in their home.
Intended user The intended user is a person with mild to severe hearing loss who needs
sound amplification.
Intended user group The intended user group consists of people of all ages with mild to severe
hearing loss or deafness that need audio, visual or sensory amplification.
Principle of operation
The Visit alerting system consists of a set of wirelessly connected transmit-
ters and receivers that are located across the home. When a transmitter
detects an activity, it signals the Visit receiver that alerts the user with
sound, flashes or vibrations. In order to use the system, you need at least
one transmitter and one receiver.
Overview
Visit LEDs Flashlight Mute / Test button
Power LED Backup batteries (BE1442) Cable holder
20
section. This will help you get the most out of your product. If
Bed shaker Power adapter
Mobile phone sensor Landline telephone
Getting started
1 Connect the power supply to the receiver and the mains outlet. Pull the battery tab on the
bottom (BE1442 only). Place the receiver on a level surface or mount it on the wall using the
wall bracket accessory (see separate instructions).
2 To test the radio link you need a Visit transmitter. Press the test button/s on the transmitter.
3
The receiver lights up a Visit LED and starts to flash. If a bed shaker is connected, it will vibrate.
A short press on the mute/test button repeats the last indication. If nothing happens, see
Troubleshooting.
1
Default signal pattern
When a transmitter is activated, the flash receiver lights up an LED, flashes and the bed shaker starts
to vibrate with a certain pace. This is called signal pattern. The transmitters determine the pattern,
and the default is as follows:
Transmitter Flash receiver
Activated source Visit LED
Door transmitter Green

Push button transmitter Green

 Telephone transmitter Yellow
Baby monitor Orange

Smoke alarm Red

 CO alarm Orange/red
Changing the signal pattern
The signal pattern can only be changed on the transmitters. See
the relevant transmitter.
2 3
Bed shaker
Flash Vibration
Yes Slow
Yes Slow
Yes Medium
Yes Fast
Yes Long
Yes Long
Changing the signal pattern
EN
for
21