Transmitting A Repeater Access Tone Rpt Tone; Activating The Frequency Inversion; Talk Around" Function - Midland CT3000 Mode D'emploi

Transmitting a repeater access tone RPT TONE

1. Press PTT and DOWN at the same time to transmit a repeater access
tone. The tone set by default is 1750 Hz.
2. If you want to change the tone frequency follow these steps:
3. Press FUNC on the front panel to enter the radio menu;
4. Select option no. 1 FUNC MENU;
5. Select RPTONE;
6. Now you can choose amongst these options:
1750 Hz - 2100 Hz - 1000 Hz - 1450 Hz
7. Push the knob to confirm your selection;
8. Press P3 twice to exit the menu and return to standby condition.

Activating the frequency inversion

The frequency inversion can be activated only if a frequency offset (positive or
negative) is enabled.
1. Keep pressed FUNC to enter the radio menu;
2. Select option n. 2 CHAN MENU;
3. Select option n. 8 REV;
4. Now select ON with the main knob.

"Talk around" function

This function can be activated only if a frequency offset (positive or negative)
is enabled.
To activate the "talk around" keep pressed FUNC and then select option
1.
no.9 TALK.
2. The icon A will be shown on the display.
3. Now you can communicate with the other users without using a repeater.
When the Talk Around function is activated, the frequency offset will be
disabled and the radio will transmit on the rx frequency.
Midland CT3000 instruction guide | 19