Publicité
Les langues disponibles
Les langues disponibles
SAFETY INSTRUCTIONS/WARNING
Ensure that the sit stand is anchored tightly to the desk/table before using it to prevent injury or damage to the product!
WARNING: DO NOT EXCEED MAXIMUM LISTED WEIGHT
CAPACITY. SERIOUS INJURY OR PROPERTY DAMAGE MAY OCCUR!
• Make sure the desk or mounting surface can support the combined weight of the sit
stand and screens.
• DO NOT lean on the keyboard platform
• DO NOT place heavy items on the keyboard platform.
• Maximum desk thickness: 2-3/4" (70mm) / Minimum desk thickness: 5/8" (16mm).
PARTS REQUIRED
Single Monitor
A (1) Lower Arm
B (1) Upper Arm
C (1) Base
D (1) Base Plate
E (1) M8 Dynamic Arm Long
F (1) Clamp Braket
G (1) VESA Plate
H (1) Keyboard Platform
I
(1) Keyboard Platform Mounting Plate
J (1) M12 x 25mm Flat Head Machine Screw
K (1) M6 x 20mm Flat Head Machine Screw
L (8) M6 x 10mm Flat Head Machine Screw
M (4) M4 x 8mm Pan Head Philips
N (4) M4 x 18mm Pan Head Philips
O (4) VESA Spacers
Additional Parts for Dual Monitor
P (1) Crossbar
Hardware
Q (1) VESA Plate
J
R (1) M6 x 30mm Flat Head Machine Screw
S (2) M5 x 14mm Flat Head Machine Screw
K
T (4) M4 x 8mm Pan Head Philips
L
U (4) M4 x 18mm Pan Head Philips
M
V (4) VESA Spacers
N
Tools
W (1) Hex L-Key 3mm (Dual only)
O
X (1) Hex Allen Key 2.5mm
Y (1) Hex L-Key 4mm
Other Tools Required
Z (1) Hex L-Key 8mm
AA (1) Hex Allen Key - 5mm
Phillips Screwdriver
2
ExtendSitStand_872201_RevD_10L_080516.indd 2-3
Extend™ Sit Stand
≤ 11.3 Kg
≤ 24.9 lbs
≤ 2.2 Kg
≤ 4.9 lbs
B
A
C
D
E
F
P
I
H
G
Q
R
S
T
W
X
Y
Z
AA
U
V
ENGLISH
ASSEMBLY
STEP 1
Assemble Base and Clamp
• Loosen the two M6x12mm screws on the clamp bracket
and remove the clamp foot assembly (fig. A).
• Attach the clamp bracket to the base using the M12x25mm
flat head machine screw (fig. B).
• Attach the base plate to the base with four M6x10mm flat
head machine screws (fig. C).
• Slide the clamp foot assembly back onto the clamp
bracket and tighten the two M6x12mm screws (fig. D).
STEP 2
Attach Base to Table
• Slide the assembled base onto the desk and tighten the
clamp feet. If needed, move the clamp feet to the lower
position on the bracket.
STEP 3
Remove Cable Cover
• Take off the plastic cable cover from the base and remove
the 180° stop screw.
fig. B
fig. A
Y
F
fig. D
fig. C
C
D
L
Y
Y
C
F
X
C
J
Z
D
3
8/8/16 10:03 AM
Publicité
