Publicité
Les langues disponibles
Les langues disponibles
WARNING
!
• Study, understand, and follow all instructions before
operating this device.
• Do not exceed rated capacity.
• Use only on hard, level surface.
• Lifting device only. Immediately after lifting, support
the vehicle with appropriately means.
• Do not move or dolly the vehicle while on the jack.
• Lift only on areas of the vehicle as specified by the
vehicle manufacturer.
• No alterations shall be made to this product.
• Failure to heed these markings may result in
personal injury and/or property damage.
SPECIFICATIONS
Model
Capacity
26022
4000 lbs.
ASSEMBLY/PREPARATION
Before Use
1. Before using this product, read the operator's manual completely and familiarize yourself thoroughly with the
product and its components, and recognize the hazards associated with its use.
2. Verify that the product and application are compatible. If in doubt, contact Omega Technical Services.
3. Assemble the two-piece handle.
4. Insert the handle into the handle sleeve until it engages the release valve in the bottom of the socket. Tighten
the handle lock fastener securely to prevent accidental removal of handle while in use.
!
WARNING: Do not lift or carry jack by handle. Handle could dislodge and jack fall, resulting in possible injury
or property damage.
5. To familiarize yourself with basic operation, rotate the release valve (pump handle):
a. Clockwise until firm resistance is felt to further turning. This is the 'CLOSED' release valve position used to
raise the saddle.
b. Counter-clockwise, but no more than 1/2 turn from the closed position. This is the 'OPEN' release valve position
used to lower the saddle.
6. With saddle fully lowered and release valve closed, pump the handle. If lift arm responds immediately, jack is
ready for use. If jack does not respond, follow Bleeding/Venting Trapped Air instruction below. Check oil level.
Proper oil level should be approximately 6mm below valve opening. Reinstall Air Vent Screw.
7. Ensure that jack rolls freely. Ensure the pump operates smoothly by raising and lowering the unloaded saddle
throughout the entire lifting range before putting into service. Replace worn or damaged parts and assemblies
with genuine Omega replacement parts only.
Bleeding/Venting Trapped Air
With the release valve in the OPEN position (step 5b. above) and saddle fully lowered, locate and remove the Air
Vent Screw. Pump handle 6 to 8 full strokes. This will help release pressurized air which may be trapped within the
reservoir. Reinstall the Air Vent Screw and check operation.
Jack Size (L x W x H)
27-1/8" x 11-7/8" x 6-1/2"
3
WARNING
!
To avoid crushing and related injuries:
• Never work on, under or around a load supported
only by hydraulic jack.
• Chock unlifted tires in both directions.
• Do not use this device to lift, level, lower, support nor
move a house, mobile home, travel trailer, camper or
any building structure.
• Be alert and sober when using this product. Do not
operate under the influence of drugs or alcohol.
Min. Height
Max. Height
3-1/2"
17-3/4"
X
Saddle Dia.
4-1/2"
Publicité
