Preparation - Omega Lift Equipment MagicLift 25057 Manuel D'utilisation

PREPARATION

Assembly
Insert handle into the handle sleeve. Tighten the bolt on handle sleeve to prevent accidental removal of handle while
in use.
Before Use
1. Verify that the product and application are compatible, if in doubt call Omega Technical Service (888) 332-6419.
2. Before using this product, read the operator's manual completely and familiarize yourself thoroughly with the
product, its components and recognize the hazards associated with its use.
3. To familiarize yourself with basic operation, locate and turn the release valve (handle):
a. Clockwise until firm resistance is felt to further turning. This is the 'CLOSED' release valve position used to
raise the saddle.
b. Counter-clockwise, but no more than 1/2 a turn from the closed position. This is the 'OPEN' release valve
position used to lower the saddle.
4. With the saddle fully lowered and release valve closed, pump the operating handle. If lift arm responds immediately,
jack is ready for use. If jack does not respond, open release valve and pump 6 ton 8 full strokes to purge air.
Close release valve and recheck operation.
5. Ensure that jack rolls freely. Raise and lower the unloaded saddle throughout the lifting range before putting into
service to ensure the pump operates smoothly. Replace worn or damaged parts and assemblies with Omega
authorized replacement parts only.
Bleeding / Venting Trapped Air
With the release valve in the OPEN position (3b.) and with saddle fully lowered, locate and remove the oil filler
plug. Pump 6 to 8 full strokes. This will help release any pressurized air which may be trapped within the reservoir.
Reinstall the oil filler plug.
! WARNING
• Study, understand, and follow all printed
materials provided with/on this product before use.
• Do not exceed rated capacity.
• Use only on hard, level surface capable of
supporting the load.
• This is a lifting device only! Immediately after
lifting, support the load with an identical pair of
appropriately rated jack stands.
• Lift only on areas of the vehicle as specified by
the vehicle manufacturer.
• Do not move or dolly the vehicle while on the jack.
• No alterations shall be made to this product.
FAILURE TO HEED THESE MARKINGS MAY
RESULT IN PERSONAL INJURY AND/OR
PROPERTY DAMAGE
! WARNING
To avoid crushing and related injuries:
• Never work on, under or around a load supported
only by hydraulic jack.
• Always use adequately rated jack stands.
• Chock each unlifted tire in both directions.
• Do not use this device to lift, level, lower, support nor
move a house, mobile home, travel trailer, camper or
any building structure.
• Be alert and sober when using this product. Do not
operate under the influence of drugs or alcohol.
3
X