Publicité
Les langues disponibles
Les langues disponibles
for recycling. You may also contact your local recycling center for
information on where to drop off the spent battery.
Installing and Removing the Battery
Pack (Fig. 1)
NOTE: Make sure your battery
pack is fully charged. To install
the battery pack into the tool
handle, align the base of the tool
with the notch inside the tool's
handle and slide the battery pack
firmly into the handle until you
FIG. 1
hear the lock snap into place.
To remove the battery pack from the tool, press the release buttons
and firmly pull the battery pack out of the tool handle. Insert it into the
charger as described in the Charging Procedures section.
Important Safety Instructions for Battery
Chargers
SAVE THESE INSTRUCTIONS - This manual contains important
safety instructions for D
WALT battery chargers.
E
• Before using battery charger, read all instructions and cautionary
markings on battery charger, battery and product using battery.
CAUTION:To reduce the risk of injury, charge only D
cadmium rechargeable batteries. Other types of batteries may
burst causing personal injury and damage.
CAUTION: Under certain conditions, with the charger plugged in to
the power supply, the exposed charging contacts inside the charger
can be shorted by foreign material. Foreign materials of a
conductive nature such as, but not limited to, steel wool, aluminum
foil, or any buildup of metallic particles should be kept away from
charger cavities. Always unplug the charger from the power supply
when there is no battery pack in the cavity. Unplug charger before
attempting to clean.
DANGER: 120 volts present at charging terminals. Do not probe
with conductive objects. Danger of electric shock or electrocution.
All manuals and user guides at all-guides.com
WALT nickel
E
4
WARNING: Don't allow any liquid to get inside charger. Electric
shock may result.
• The charger and battery pack are specifically designed to
work together. DO NOT attempt to charge the battery pack with
any chargers other than the ones in this manual.
• These chargers are not intended for any uses other than charging
D
WALT rechargeable batteries. Any other uses may result in risk
E
of fire, electric shock or electrocution.
• To reduce risk of damage to electric plug and cord, pull by plug
rather than cord when disconnecting charger.
• Make sure cord is located so that it will not be stepped on, tripped
over, or otherwise subjected to damage or stress.
• An extension cord should not be used unless absolutely necessary.
Use of improper extension cord could result in risk of fire, electric
shock, or electrocution.
• An extension cord must have adequate wire size (AWG or
American Wire Gauge) for safety. The smaller the gauge number of
the wire, the greater the capacity of the cable, that is 16 gauge has
more capacity than 18 gauge. When using more than one
extension to make up the total length, be sure each individual
extension contains at least the minimum wire size.
Recommended Minimum AWG Size for Extension Cords
Total Extension Cord Length (feet)
25
50
75
100
Wire Gauge
18
18
16
16
• The charger is ventilated through slots in the top and the bottom of
the housing. Do not place any object on top of charger or place the
charger on a soft surface that might block the ventilation slots and
result in excessive internal heat. Place the charger in a position
away from any heat source.
• Do not operate charger with damaged cord or plug — have them
replaced immediately.
• Do not operate charger if it has received a sharp blow, been
dropped, or otherwise damaged in any way; take it to an authorized
service center.
125
150
175
14
14
12
Publicité
