Before Requesting Service - Panasonic MC-UG223 Manuel D'utilisation

BEFORE REQUESTING SERVICE

WARNING
Disconnect the electrical supply before servicing or cleaning the vacuum cleaner.
Failure to do so could result in electrical shock or personal injury from vacuum
cleaner suddenly starting.
Review this chart to find do-it-yourself solutions for minor performance
problems. Any service needed, other than those described in these
Operating Instructions, should be performed by an authorized service
representative.
PROBLEM
Vacuum cleaner
will not run.
Poor job of dirt
pickup.
Dust escapes
the paper bag.
Electrical Shock or Personal Injury Hazard
POSSIBLE CAUSE
1. Unplugged at wall outlet.
2. ON-OFF switch not turned on.
3. Tripped circuit breaker/blown
fuse at household service panel.
1. Full or clogged dust bag.
2. Broken belt.
3. Clogged hose or nozzle.
4. Hose not inserted fully.
5. Worn agitator.
6. Dust cover improperly installed.
1. Bag improperly installed.
2. Bag torn.
POSSIBLE SOLUTION
1. Plug in firmly. Push ON-OFF
switch to On.
2. Push ON-OFF switch to ON.
3. Reset circuit breaker or replace
fuse.
1. Change bag.
2. Replace belt.
3. Clean hose or nozzle area.
4. Insert hose.
5. Replace agitator.
6. Properly install dust cover.
1. Properly install bag.
2. Replace bag.
- 36 -