Cleaning Agitator - Panasonic MC-UG223 Manuel D'utilisation

Belt
Courroie
Correa
Motor Shaft
Arbre d'entraînment
du moteur
Eje del motor
+
Groove
Ouverture
Ranura
+
Replacing Belt
Agitator
Agitateur
Agitador
End Cap
Bouchon
Tapa del extremo

Cleaning Agitator

➢ Remove worn or broken belt.
➢ Loop new belt (Panasonic Type UB8
only) around motor shaft and belt
pulley; see illustration for correct
belt routing.
➢ Reinstall agitator back into nozzle
housing grooves.
➢ After reinstalling the agitator, turn it
by hand to make sure that belt is not
twisted or pinched and that all
rotating parts turn freely.
➢ Reinstall lower plate.
➢ Clean agitator after every five uses
and every time the belt is replaced.
➢ Remove lower plate.
➢ Cut off any carpet pile and lint
entangled around agitator with a pair
of scissors.
➢ Remove agitator.
➢ Remove any string or debris located
on the end caps.
➢ Reinstall agitator and lower plate.
- 30 -