Handling And Operation - easymaxx BY-EWB-2000-A01 Mode D'emploi

EN
Attaching / Detaching Nozzles
CAUTION – Danger of Burns! The hot nozzles must cool down after use before they
can be detached. We recommend wearing protective gloves.
• Attaching: Plug the nozzle you want onto the outlet pipe (1) and twist it anticlock-
wise to fi x it in place. When you do this, make sure that the two locking lugs inside
the nozzle are guided correctly into the two recesses on the outlet pipe (Picture D).
Important! When the grill lighter nozzle (C) is attached, the holes must be pointing
upwards.
• Detaching: Twist the nozzle clockwise to release it and pull it off the outlet pipe.

Handling and Operation

PLEASE NOTE!
■ Always check the device for damage before putting it into operation. The de-
vice should only be used when it is undamaged and in working order! Do not
use the device if it has malfunctioned, fallen or been dropped in water. Have it
checked in a specialist workshop before using it again.
■ Only connect the device to a properly installed plug socket. The plug socket must
also be readily accessible after connection so that the connection to the mains can
quickly be isolated. The mains voltage must match the technical data of the device.
■ Make sure that the connecting cable is not squashed, bent or laid over sharp edges
and does not come into contact with hot surfaces (e. g. of the device) or hot materials
(e. g. oil, lacquer, embers).
■ Always maintain a suffi cient safe distance between the heat jet and the connecting
cable!
For an increased level of safety, we recommend wearing both protective gloves and
safety goggles when using the device.
1. If necessary, attach accessories to the device (see the "Accessories" chapter).
2. Fully unwind the connecting cable. Please Note: If the device is used with the ex-
tension rod (D) and handle (A), hang the connecting cable into the cable guide (4).
3. Plug the mains plug into a properly installed plug socket that is easily accessible.
4. To switch on the device, move the On / Off switch (3) to the temperature level you
want (position I / II).
5. To switch off the device, move the On / Off switch to the 0 position.
To speed up the cooling process once the device has moved to temperature level
II, move the On / Off switch to position I and allow the device to operate for a while
before it is switched off .
6. Fold out the stand (6) and place the device on it (Picture E).
7. Pull the mains plug out of the plug socket and allow the device to cool down com-
pletely.
09220_Inlay_DE-EN-FR-NL_A5_V1.indb 16 09220_Inlay_DE-EN-FR-NL_A5_V1.indb 16
16
03.12.2019 10:55:41 03.12.2019 10:55:41