Publicité
Les langues disponibles
Les langues disponibles
Operating Instructions
Quick start
1. Ensure the clear plastic battery protection tab is removed from the bottom of the remote control
(see page 4).
2. To use the remote control, point it at the infrared sensor at the cable entry to the light unit.
3. Press
to set the clock. Press once to adjust the hour and twice to adjust the minute.
Use
and
The time setting will be automatically saved after ten seconds, or you can press
your user set program with the updated time.
24/12
4. Press
to choose between 24 hour and 12 hour clock format.
RUN
5. Press
to run the set program (details of the factory set program on page 8).
6. Press
OFF
to switch the light off.
7. Press
to enter storm mode. Use
RUN
Press
to return to the set program.
COLOUR
8. Press
to enter a colour demo. Use
DEMO
In the slowest settings this can be used to simulate clouds passing over. Press
set program.
C/
F/
O
O
9. Press
repeatedly to cycle the display through, showing the temperature of the light unit in °C
W
and °F and the electrical power being drawn by the light unit in Watts.
10. Press
to slave the unit from another controller (sold separately).
SLAVE
to adjust up or down.
and
to change the frequency of lightning strikes.
and
to change the speed of the transitions.
6
RUN
to go back to
RUN
to return to the
Publicité
