Electrolux AEG Santo W 9 88 20-4i Mode D'emploi page 55

Fault
Appliance doesn't work.
Inadequate cooling
chamber temperature.
Interior light doesn't work.
The compressor doesn't
cut in immediately after
changing the temperature
setting.
Error message F1 on
control panel.
Error message F2 on
control panel.
Error message F3 on
control panel.
Possible cause
Appliance is not switched
on.
Mains plug is loose or
not plugged in.
Fuse has triggered or is
defective.
Socket is defective.
Temperature has not
been properly set.
Door was open for a
long period.
The appliance is positio-
ned next to a heat source.
LED is defective.
This is normal and not
due to a fault.
Upper sensor defective.
Lower sensor defective.
Fan defective.
Solution
Switch on.
Insert the mains plug.
Check fuse and replace if
necessary.
Faults with the mains
supply must be repaired by
a qualified electrician.
Please see under
"Commissioning".
Only open door for as long
as necessary.
Please see under
"Installation site".
Please see under "LED
lighting".
The compressor cuts in
automatically after a short
time.
Contact customer service.
Contact customer service.
Contact customer service.
55