Kampa Caravan AIR Guide D'utilisation page 7

Welcome
Thank you for purchasing your Kampa awning. Please read these instructions carefully before attempting set up and
retain for future reference. If used properly, your awning should give you years of trouble free use. We recommend
that your awning is insured against accidental and storm damage as this is not covered by the warranty.
IMPORTANT - PLEASE READ:
Under certain conditions all awnings will suffer from internal condensation. Depending upon
the time of year, the weather and the amount of moisture in the ground, the condensation
could be quite severe and is commonly mistaken for leaking, especially as it can run down
the inside of the roof and drip off ties, tapes and other internal fittings. If you suspect
your awning is leaking it is almost certainly condensation. Laying a waterproof groundsheet (not a breathable
carpet) throughout the whole awning will help and condensation can also be improved by ensuring adequate
ventilation. On some awnings we offer an optional roof lining that can also help prevent condensation and
catch any drips that fall from the roof.
The Pro awning material has a waterproof PU coating over its entire surface and the main seams of your awning
have been factory taped to help prevent leakage (not Expert/All-Season). Depending upon your expectations,
it may be necessary to treat the remaining seams with a seam sealant. Seams treated with seam sealant cannot
leak. Seam sealant should also be applied to areas where the taping is damaged or has peeled away through
wear and tear. It can also be applied to areas where a leak may have developed. Kampa seam sealant is
available from your dealer.
The awning keder beading is sewn to the awning with a special waterproof sewing thread. This thread swells
when wet to fill the needle holes but the thread needs to become wet several times before it is totally effective.
This process is known as 'weathering' and it may take several soakings for the weathering to be fully effective.
This area can also be treated with seam sealant.
This awning is designed for use in light to moderate weather. During very strong winds or snowfall
we recommend that you take your awning down. The awning is designed for touring use; it is not
designed for seasonal pitch (except All-Season) or commercial use.
We recommend a trial run before using your awning for the first time. This will allow you to
familiarise yourself with the awning, its set up and any limitations the awning may have for your
particular use. Please also check your caravan awning rail to ensure that it is not damaged or has
any sharp edges that could damage your awning.
Siting
Choose a site that is flat and, if possible, protected from the wind. Sloping ground may have an adverse affect on
your finished awning.
Set-Up
Visit www.kampa.co.uk for additional resources
and video how-to guides on setting up your awning
To protect your awning from dirt and damage, it may be beneficial to lay a groundsheet or awning carpet down
before unpacking. Unpack the awning, separate and identify the different parts.
Slide the awning keder beading, on the rear of the awning roof (see Diagram 1a/1b), through the caravan awning
channel until it is in your required position. The awning should be positioned on a horizontal part of the caravan (see
Diagram 2). Ensure all removable panels are fully zipped into the awning.
Pegging Point A: Peg the rear corners of the awning (3a/3b where applicable). Each corner should be pegged
slightly under the caravan to pull the awning as close to the caravan as possible. Pegging Point A on Rally, Ace, Frontier
AWN-AIR-UM-0917-Rev.B 7